b'-MW SPECIFICATIONSDeltaCool-MW Single Span TablesSpan Pressure (kPa)mm 75mm 100mm 150mm1800 2.47 3.30 5.00 Detail A2400 1.93 2.57 4.013000 1.43 1.90 2.99 0.60mm DeltaCool-MW Bracing Capacity3600 1.18 1.57 2.40 Panel Height (m) 2.4 1.2* 4.8*4200 1.02 1.35 2.03 Kn/m 5.0 10.0 2.54800 0.85 1.13 1.69 Bracing Units (BU) 100 200 505400 0.71 0.94 1.416000 0.60 0.80 1.20 * Figures for 1.2m & 4.8m high panels are extrapolated. It is acceptable to extrapolate Bracing Capacity heightsbetween 1.2m & 4.8m. For heights outside of this dimension range, Diaphragm Analysis is required to establish Bracing DeltaCool-MW Multi Span Tables Capacity.Span Pressure (kPa) Shear Load Transference - Shear load is transferred by rivets into the floor / ground surface or the perpendicular walls, ceiling mm 75mm 100mm 150mm & roof at a rate of 1.21 kN per 4.0 mm diameter rivet.1800 1.98 2.64 3.96 Fixing rivets at 200mm centres complies with the 20-minute 2400 1.55 2.06 3.09 flamebarrierrequirementsanddelivers14.5kNofshear capacity transfer per panel (6 on each side) horizontally, and 3000 1.14 1.52 2.28 12.1 kN per metre in vertical joints. Limited by the ability of the panel to transfer the shear.3600 0.95 1.25 1.884200 0.83 1.09 1.64 DeltaCool-MW Acoustic Values4800 0.71 0.94 1.415400 0.62 0.82 1.23 75mm 125mm6000 0.57 0.76 1.14 Frequency STC 24.00 23.00RW 25.00 24.00DeltaCool-MW Internal ApplicationAs at the stated Version Date all of the information contained Span Pressure (kPa) in this document is correct. Please check on our WebPage to ensure that youre referencing the current version. mm 75mm 100mm 150mmWalls 7300 8500 9600(Non Load Bearing)Ceilings 3500 4500 4200Delta Panels Pty Ltd - ABN: 11 147 861 292P: +61 07 3271 2170 Head Office: 731 Boundary Road, Richlands, Qld 4077E: info@deltapanels.comSydney Depot: 11 The Old Northern Road, Narellan, NSW 2567 Version Date: 2024-04-12W: www.deltapanels.com'