b'DeltaDualCore TMPanels DeltaDualCore TMPanelsDELTADUALCORE PANELS- For Awning and Patio Roofing that finishes within 900mm of the boundary line.PANEL LAYOUT- Design ConfigurationCERTIFICATION LIMITSDelta DualCore is limited to a roof covering for Awnings and Patios.Certification is only for DeltaTrim-DC and DeltaOrb-DC Panel and fixings but not the structure that the panelsare affixed to.Any portion of the DeltaTrim-DC and DeltaOrb-DC Panel that is located within the 900mm site boundary must contain the mineral wool portion of the DeltaTrim-DC and DeltaOrb-DC Panel.Any portion of the DeltaTrim-DC and DeltaOrb-DC Panel that is located within the 900mm site boundary must NOT contain any Expanded Polystyrene with fire retardant (EPS-FR) core material.DeltaTrim-DC or DeltaOrb-DC panels top skin consisting of 0.45 mm Colorbond Steel and bottom skin consisting of 0.55 mm UniCote Steel.HANDLING AND INSTALLATIONDeltaDualCore Panels utilises a combination of Expanded Polystyrene with fire retardant (EPS-FR) and Mineral Wool (MW) insulated core material. The fibrous structure of Mineral Wool makes it easy to fracture the woven fibres if handled and installed incorrectly. Please ensure that correct lifting equipment is used when the panels are transported and lifted into position. Refer to the Handling & Installation Manual - Roof Systems for the correct Crane & Sling Procedures. When installing DeltaDualCore Panels only step onto the section of the panels that are supported by the underneath roof structure. Do not step on unsupported spans. The whole of the Mineral Wool section of the panel can not overhang the underneath roof structure, it must be fixed and fully supported. Once installed it is classified as trafficable when used for maintenance purposes only. The following recommendations should be observed at all times.RecommendationsWear flat, rubber soled shoesWalk over the roof supporting beams avoiding the mineral wool section of the panelSpread your weight over as many roof crests as possibleCrawl boards must be used when accessing areas not supported by a structureDelta Panels Pty Ltd - ABN: 11 147 861 292E: info@deltapanels.comHead Office: 731 Boundary Road, Richlands, Qld 4077P: +61 7 3271 2170 Version Date: 2024-11-07W: www.deltapanels.com Sydney Depot: 11 The Old Northern Road, Narellan, NSW 2567 P: +61 2 4611 7712'