b'DeltaDualCore Panel Awning Systems CertMark ConcernSotera ResponseSection Actioned we have 3 panels available in 2assessment to be strictly qualitative. We profiles and in 4 sizes (24used method (iv) using qualitative and panels in total) noted in thequantitative assessment to demonstrate report, with contradictions thatthat the applicable performance Panel 2 from Design Config 2,requirements are achieved in line with being outside the scope of thethat permitted under the CodeMark certification.protocol.The report addresses design configuration 1 and design configuration 2 as per Section 3.2, with DeltaOrb and DeltaTrim panels allowed to be used interchangeably to form the roof. Any perceived contradiction has been removed.Rev 1-4: AS1530.3 fire test certificate for Bluescope Colorbond Permagard Steel has been added to Appendix D. Rev 1-3: Further AS1530.3 fire test reports have been added in Appendix D for DeltaTrim and DeltaOrb sandwich panel systems. Rev 1-2: Following further comments from the client, the report has been updated to clarify requirements for steel sheeting to be used as part of the DeltaDualCore panel system (Sections 1.3, 2.4, 3 & 4.4). Specifically, pre-finished steel sheeting with combustible surface finish not exceeding 1 mm thickness and with a spread of flame index no greater than 0 in accordance with NCC Clause 3.7.1.1(e). Rev 1-1: Minor wording updates to clarify roof structure use as awning, patio or car port following review by the client. Rev 1-0: This report aims to inform stakeholders to facilitate agreement on performance solutions. Information and agreement is sought on matters including: critical building and occupant characteristics, proposed details of performance solutions, DtS variations, issues, hazards, design fires and scenarios, methodologies and acceptability criteria. 2.3Scope of Project. The assessment relates to the final state of the building. This assessment and report does not address any issues of variation from deemed-to-satisfy requirements and occupant safety that may arise as a result of partial completion and partial occupation of the building. Analysis of intentional fire incidents such as arson is not contemplated as part of this assessment. This assessment will address the issues of variation from deemed-to-satisfy provisions of the BCA, which are identified in the summary of this report (Section 1).The assessment is concerned primarily with the life safety of occupants.The fire safety systems to achieve this are outlined in the report in principle.The assessment does not consider property protection, business continuity issues, environmental protection and insurance requirements unless specifically identified within this report.This assessment only addresses the specific issues identified in the context that the remainder of the building is fully compliant with the deemed-to-satisfy provisions of the NCC.2.4Supporting Information The fire engineering assessment described in this report is based on the following information: Revision 1-1110'