b'CAUTION RISK OF INJURYWeartherequiredPPE(Gloves&SafetyGlasses)atalltimeswheninstalling,servicingor performing maintenance.Avoid direct eye contact with the light when it is operating.WARNING RISK OF BURNAllow the light to cool before handlingDo not touch the enclosure or light sourceDo not exceed the maximum wattage marked on the products labelsCAUTION RISK OF FIREKeep combustible and other materials that can burn away from the lamp/lensIf installing into the ceiling of an Delta Insulated Panel its recommended to allow an airspace gap of 10mm from the back of the light to the Expanded Polystyrene Fire Retardant (EPS-FR) core. This is to allow for convection or conduction coolingThe maximum operating temperature must not exceed 85 o C, do not operate at a temperature higher than this.Be careful that no sharp edge is remaining after the cut-out cavity is made, especially if going into steel skinned panels.CAUTION RISK OF PRODUCT DAMAGENever connect components under load.Do not mount or install any product in a manner that can cut the outer jacket or damage the wire insulation.If connecting to a dimmer ensure that the dimmer is compatible with the information specifically recommended for the LED lighting system.Do not install any component that has any visible damage to the cables or connectors.Never install the LED lighting system in places where they will be exposed to direct rain, high humidity, extreme temperature changes or restricted ventilation.There are no user serviceable parts inside the unit. Do not rewire, reconfigure or modify the unit in any way.FAILURE TO FOLLOW ANY OF THESE INSTRUCTIONS COULD VOID THE PRODUCT WARRANTYDelta Panels Pty Ltd - ABN: 11 147 861 292P: +61 07 3271 2170 Head Office: 731 Boundary Road, Richlands, Qld 4077 Page 2 of 8 E: info@deltapanels.comSydney Depot: 11 The Northern Road, Narellan, NSW. 2567 Version Date: 2024-01-10W: www.deltapanels.com'