b'STEP 5 - MOUNT THE LED DRIVERMount the LED driver at the fixing points on the back of the product case.Its recommended that the LED driver is mounted in the roof cavity in an easy to access location.For a Stand Alone structure where it is not possible to mount the LED driver in the roof cavity it is recommended to place the device behind the rear barge capping.STAND ALONE MOUNTING OF LED DRIVERSTEP 6 - DETERMINE THE REQUIRED CABLE LENGTHMeasure the distance from the position of the LED light to the LED driver and determined the length of cable required.The LED Light assembly comes with a both 6 metre and a 3 metre cable and can be configured to reach 9 metres.STEP 7 - CONNECT CABLE TO THE LED DRIVEROnce the required cable length is determined and the cable combination is created, attach the cable to the LED driver by the Thread-Lock Cable Joiner.STEP 8 - RUN THE CABLE AND CONNECT TO THE LIGHTAfter connecting the cable to the LED Driver run the cable along the cable recess track on the edge of the Panel.Make a track from the cable recess track to the light cut-out recess and then pull the cable through to the cut-out recessConnect the light and the cable by the Thread-Lock Cable Joiner.Delta Panels Pty Ltd - ABN: 11 147 861 292P: +61 07 3271 2170 Head Office: 731 Boundary Road, Richlands, Qld 4077 Page 7 of 8 E: info@deltapanels.comSydney Depot: 11 The Northern Road, Narellan, NSW. 2567 Version Date: 2024-01-10W: www.deltapanels.com'