b'STEP 9 - MOUNT THE LED LIGHT FIXTUREMount the spring on the back of the light, be careful not place your hands underneath the spring clips to avoid any hand injuries.Ensurethatthelightiscorrectlyseatedintherecess, that the spring clips are fully engaged and are securely holding the LED light.STEP 10 - CONNECT THE LED DRIVER TO MAINS POWERTurn on the mains power to the GPO that the 3-prong-plug for the LED driver will be connected to.Plug the power lead into the GPO.STEP 11 - TURN ON THE LED LIGHTTurn on the power to the LED light.TROUBLE SHOOTINGIf the light does not turn on within 5 seconds, or if the light is functioning irregularly turn off the power source.Carefully remove the LED light and double check all connections and wiring.Replace individual components to isolate any faulty part.Have a qualified licensed electrician verify that the line voltage is correct.Should any further information be required please contact Delta Panels Pty Ltd at info@deltapanels.comWARNINGSDo not use any other driver except the one provided as part of the LED Lighting kit.Do not connect multiple LED light modules to a single driver.Do not open the LED Light Module or the LED Driver Module. There are no serviceable parts inside.Do not change parts or perform any modifications on any parts of the LED light fixture kit.Do not operate the LED driver if the LED light is not connected.FAILURE TO FOLLOW ANY OF THESE INSTRUCTIONS COULD VOID THE PRODUCT WARRANTYDelta Panels Pty Ltd - ABN: 11 147 861 292P: +61 07 3271 2170 Head Office: 731 Boundary Road, Richlands, Qld 4077 Page 8 of 8 E: info@deltapanels.comSydney Depot: 11 The Northern Road, Narellan, NSW. 2567 Version Date: 2024-01-10W: www.deltapanels.com'