b'STEP 4 - PLACE THE DELTAPANEL LIGHT TMINTO POSITIONEnsure that the light panel is completely seated into the receiver channel to create a weatherproof seal.STEP 5 - MOUNT AND CONNECT THE LED DRIVERFor ease of access the holding frame is designed so that the LED Driver can be positioned between the light panel and the ceiling surface.Alternatively the LED driver can be mounted in the roof cavity in an easy to access location.STEP 6 - CONNECT THE LED DRIVER TO MAINS POWERTurn on the mains power to the GPO that the 3-prong-plug for the LED driver will be connected to.Plug the power lead into the GPO.STEP 7 - TURN ON THE LED LIGHTTurn on the power to the DeltaPanel Light TM .TROUBLE SHOOTINGIf the DeltaPanel Lightdoes not turn on within 5 seconds, or if the light is functioning irregularly turn off the power source.Carefully remove and double check all connections and wiring.Replace individual components to isolate any faulty part.Have a qualified licensed electrician verify that the line voltage is correct.Should any further information be required please contact Delta Panels Pty Ltd at info@deltapanels.comWARNINGSDo not use any other driver except the one provided as part of the DeltaLum LED light kit.Abide by the recommendations attached for LED driver loads.Do not open the LED Driver Module. There are no serviceable parts inside.Do not change parts or perform any modifications on any parts of the LED Light fixture kit.Do not operate the LED Driver if the DeltaPanel Light is not connected.FAILURE TO FOLLOW ANY OF THESE INSTRUCTIONS COULD VOID THE PRODUCT WARRANTYVersion Date: 08.04.2020Delta Panels Pty LtdP: +61 07 3271 2170E: info@deltapanels.com W: www.deltapanels.comA: 731 Boundary Road, Richlands, Qld 4077 ABN: 11 147 861 292'