b'RECOMMENDED INSTALLATION STEPSSTEP 1 - ENSURE POWER IS DISCONNECTEDEnsure that there is no live power in the work area, especially where the recess holes are going to be cut.Make sure that the power supply is switched off to the GPO which will power the Led Driver.STEP 2 - DETERMINE THE REQUIRED LENGTH OF THE LED STRIPSRefer to the chart below outlining the various LED Strips lengths and recommended driver combinations.STEP 3 - INSTALL THE LED STRIPS INTO THE SKYLIGHTRemove the adhesive tape from the rear of the LED Strips and install within the light channel.Place pressure on the strip to ensure the adhesive tape has made good surface contact.STEP 4 - PLACE THE LENS COVERS INTO POSITIONClip the lens cover over the LED Strips.Ensure that the clip is completely seated into the receiver channel to create a weatherproof seal.Version Date: 08.04.2020Delta Panels Pty LtdP: +61 07 3271 2170E: info@deltapanels.com W: www.deltapanels.comA: 731 Boundary Road, Richlands, Qld 4077 ABN: 11 147 861 292'