b'STEP 5 - MOUNT THE LED DRIVERMount the LED driver at the fixing points on the back of the product case.Its recommended that the LED driver is mounted in the roof cavity in an easy to access location.STEP 6 - CONNECT CABLE TO THE LED DRIVEROnce the required cable length is determined and the cable combination is created, attach the cable to the LED driver by the Thread-Lock Cable Joiner.STEP 7 - CONNECT THE LED DRIVER TO MAINS POWERTurn on the mains power to the GPO that the 3-prong-plug for the LED driver will be connected to.Plug the power lead into the GPO.STEP 8 - TURN ON THE LED LIGHTTurn on the power to the DeltaLum LED light.TROUBLE SHOOTINGIf the light does not turn on within 5 seconds, or if the light is functioning irregularly turn off the power source.Carefully remove and double check all connections and wiring.Replace individual components to isolate any faulty part.Have a qualified licensed electrician verify that the line voltage is correct.Should any further information be required please contact Delta Panels Pty Ltd at info@deltapanels.comWARNINGSDo not use any other driver except the one provided as part of the DeltaLum LED light kit.Abide by the recommendations attached for LED driver loads.Do not open the LED Driver Module. There are no serviceable parts inside.Do not change parts or perform any modifications on any parts of the LED Light fixture kit.Do not operate the LED Driver if the DeltaLum LED light is not connected.FAILURE TO FOLLOW ANY OF THESE INSTRUCTIONS COULD VOID THE PRODUCT WARRANTYVersion Date: 08.04.2020Delta Panels Pty LtdP: +61 07 3271 2170E: info@deltapanels.com W: www.deltapanels.comA: 731 Boundary Road, Richlands, Qld 4077 ABN: 11 147 861 292'