b'Certificate number: CM40346 Certification Body: THIS IS TO CERTIFY THAT Delta MW and EPS Panel Class 10a Awning and Patio Roof System ABN: 81 663 250 815 JAS-ANZ AccreditationType and/or use of product:Description of product:No. Z4450210AK PO Box 273,To be used for Class 10a Awning and Patio structures that are attached or adjacent to a Class 1aDelta MW and EPS Panel Class 10a Awning and Patio Roof System incorporates DeltaTrim-MW or Palmwoods Qld 4555building that run parallel with a side boundary and is within 900mm of that side boundary.DeltaOrb-MW Panels (within 900mm of the boundary) and DeltaOrb EPS-FR or DeltaTrim EPS-FR Australiapanels of the same thickness and profile for the remaining section of the structure. Refer A2. P: +61 7 5445 2199 www.cmicert.com.au COMPLIES WITH THE FOLLOWING BCA PROVISIONS AND STATE OR TERRITORY VARIATION(S)BCA 2022 office@cmicert.com.auVolume OneVolume TwoPerformance Requirement(s):Not ApplicableH3P1(1)Contributes to the Spread of fire subject to Limitation and Certificate Holder:Condition 1 Deemed-to-Satisfy Provision(s):Not ApplicableNot ApplicableDelta Panels Pty LtdState or territory variation(s): Not ApplicableNot Applicable ABN: 11 147 861 292 731 Boundary Road,SUBJECT TO THE FOLLOWING LIMITATIONS AND CONDITIONS AND THE PRODUCT TECHNICAL DATA IN APPENDIX A AND EVALUATION STATEMENTS IN APPENDIX B Richlands, QLD, 4077Limitations and conditions:Building classification/s: Australia 1.Compliance with H3P1(1) is subject to site specific performance solution to the satisfaction of the Appropriate Authority as described by the NCC. Class 10aPh: 07 3271 21702.The Delta MW and EPS Panel Class 10a Awning and Patio Roof System is only to be used as a Class 10a Awning and Patio structure.www.deltapanels.com.au3.In the absence of a site-specific performance solution, this system must not be used to facilitate the exemptions for a carport specified in Part 9.2.8 Open carports of the ABCB Housing Provisions.4.Construction shall be in strict accordance with A5 of this Certificate of Conformity.5.Compliance with H3P1(1) is dependent on the system as specified in A3. Any deviation from the described system does not form part of this Certificate of Conformity.6.The structural support members are designed and engineered separately as per project requirements by building designers and engineers. 7.The use of the certified product/system is subject to these Limitations and Conditions and must be read in conjunction with the Scope of Certification below.Scope of certification: The CodeMark Scheme is a building product certification scheme. The rules of the Scheme are available at the ABCB website www.abcb.gov.au. This Certificate of Conformity is to confirm that the relevant requirements of the Building Code of Australia (BCA) as claimed against have been met. The responsibility for the product performance and its fitness for the intended use remain with the Certificate Holder. The certification is not transferrable to a manufacturer not listed on Appendix A of this certificate. Date of issue: 09/05/2025 Glen GugliottiCMIDon GrehanUnrestricted Building CertifierDate of expiry: 11/05/2028 Certificate number: CM40346-I02-R00This certificate is only valid when reproduced in its entirety.Page 1 of 6'