b'Fire assessment report R1.0 3.0Requirements and limitations of this assessment+The scope of this report is limited to an assessment of the variations to the tested systems described in section 4.3.+This report details the methods of construction, test conditions and assessed results in accordance with AS ISO 9705:2003 (R2016) and AS 5637.1:2015.+This assessment applies to assessed products used as internal wall and ceiling lining. +This report relies on test evidence and applies only to the specific specimens tested. It does not verify ongoing compliance or the performance of future production batches. +This assessment report has been prepared based on the fire hazard performance and condition of the products/systems at the time they were tested. Any deterioration of fire hazard performance due to external factors including but not limited to passage of time and exposure to elementsis not considered in this report. +Jensen Hughes has provided this report on the fire performance of building elements in a controlled laboratory setting, strictly within the parameters allowed by the test standards and building regulations. The outcome of this report are intended to assist in verifying the suitability of the product or system for practical use in specific applications. +This report is only valid for the assessed systems and must not be used for any other purpose. Any changes with respect to size, construction details, loads, stresses, edge or end conditionsother than those identified in this reportmay invalidate the findings of this assessment. If there are changes to the system, a reassessment will need to be done by an Accredited Testing Laboratory (ATL) that is accredited to the same nominated standards of this report.+This report has been prepared using information provided by others. Jensen Hughes has not verified the accuracy and/or completeness of that information and will not be responsible for any errors or omissions that may have been incorporated into this report as a result. +This assessment is based on the proposed systems being constructed under comprehensive quality control practices and following appropriate industry regulations and Australian Standards on quality of materials, design of structures, guidance on workmanship and expert handling, placing and finishing of the products on site. These variables are beyond the control and consideration of this report. Page 7 of 21 Copyright 2025 Jensen Hughes, Inc.All Rights Reserved. T1124 PAC'