b'Fire Engineering Assessment, Revision 01 DeltaCool, DeltaSecrectFix, DeltaTrim at 100 mm and 75 mm Fire Performance, Project No. 25367 25367-SFE-FEA-01-Delta Panel Fire Performance oThe core is mineral wool with the specifications outlined in Appendix DSpecifications for the Mineral Wool, with a nominal density of 100 kg/m 3 . oThe mineral wool core shall have a nominal thickness of no less than 74 mm and no greater than 99 mm excluding the peaks within the DeltaTrim profiled skin. oThe peaks on the corrugated DeltaTrim panel shall be completely filled with mineral wool, be no greater than an additional 33 mm onto the thickness of the mineral wool core (for a total thickness of 132 mm of mineral wool at a peak), the lateral width of the peak shall be no greater than 75 mm, and spaced at no less than 250 mm between centres, as indicated in Figure 4-15.oThe steel skins may be pre-painted and shall have a nominal thickness of no less than 0.6 mm inclusive of the painted coating on the internal side of the panel. The external side of the panels shall have a nominal thickness of no less than 0.4 mm inclusive of the painted coating.oThe adhesive layer between the steel skin and the mineral wool does not exceed 1 mm, or a total of 2 mm throughout the entirety of the cross section of the panel in aggregate. oThe joint and corner detailing shall be constructed in accordance with Figure 4-4, Figure 4-5, Figure 4-6, Figure 4-7, Figure 4-8, and Figure 4-9 with equivalent fasteners, channels, angles, and sealants. 4.1.4Tested Assembly DetailingFigure 4-1Left and right wall panel layout (pg. 13, RTF252619 R1.0 by Jensen Hughes). Page 17'